Xprog-M V5.5ECU Programmer Newest Version V5.5Release

This newest XPROG-M Programmer V5.5 is a continuation of the project XPROG and it now supports more than 450 units (serial EEPROM`s, Microcontrollers (MCU), Electronics Control Units (ECU), DashBoards, Immobilizers, Calculators and others).

 1.Language Available

Our XPROG-M Programmer V5.5 is English only.

2.Computer Requirements

§           Processor: INTEL Pentium 60MHz or faster (depends on operating system)

§           Memory (RAM): 64MB (depends on operating system)

§           Hard drive: 20MB free space

§           Communication: One free physical COM or USB port

§           Operating system: Microsoft Windows NT/ME/2000/XP/VISTA/WIN7

3.What need to pay attention when use this XPROG-M Programmer V5.5?

§           1. Please disable the computer anti-software . if not , will kill the software.

§           2. Close the internet. If not ,this will damaged the hardware ,and cannot be repaired without any warranty.

§           3. Uninstall all the xprog-m, or xprog box software -higher or lower software before in your computer, make sure that your pc only install our software for our xprog-box 5.45 , our xprog-box hardware cannot work on other lower or higher software. the hardware will be burned and damaged ,cannot be repaired without any warranty if you run our hardware on other software .

§           4. Never try to UPDATE online or offline, the hardware will be burned damaged if you want to try to upgrade it online or offline from official website, without any warranty.

§           5. we cannot refund ,cannot exchange, cannot repair if you do not listen to those advice above. It means that you accept those conditions if you have ordered our XPROG-M Programmer V5.5.